Signal Conditioning

The hardware Trigger and EndTrigger signals issued from differential inputs are conditioned before being applied to the acquisition controller.

Each signal is sampled at a constant frequency of 50 MHz and flows through a digital filter.

With such a filter:

All the pulses having a duration larger than T_HIGH[ns] are transmitted to the output.
All the pulses having a duration smaller than T_LOW[ns] are blocked.
Pulses having duration in between the above mentioned limits can be transmitted or blocked.

The following table shows for each possible value of the respective TrigFilter and EndTrigFilter parameters:

Note. TrigFilter and EndTrigFilter are not relevant for isolated inputs.