Isolated I/O Lines (A<1,2>)

MultiCam Boards Documentation > GRABLINK series Documentation > GRABLINK Value Handbook > Board Specifications > DC/AC Characteristics > Isolated I/O Lines (A<1,2>)

Isolated I/O Lines (A<1,2>)

Isolated I/O characteristics


Parameter	Measurement condition	Value			Unit
Parameter	Measurement condition	Min.	Typ.	Max.	Unit
High-level output voltage		4.5	—	5.2	V
High-level output current				8	mA
Low-level voltage		0	—	600	mV
Low-level current				100	mA
Input current	12V input, high level			5	mA
Input current	12V input, low level			50	mA
Input current	TTL input, high level			1200	mA
Input current	TTL input, low level			2	mA

Output Mode

In the following schematics, the output pin corresponds to the A1 or A2 signals.

GrablinkOEqSchITTLOutModeHigh

Equivalent schematic in ITTL output mode in high state

GrablinkOEqSchITTLOutModeLow

Equivalent schematic in ITTL output mode in low state

GrablinkOEqSchITTLActLModeHigh

Equivalent schematic in ITTL active high mode

GrablinkOEqSchITTLActHModeLow

Equivalent schematic in ITTL active low mode

Input Mode

In the following schematics, the input pin corresponds to the A1 or A2 signals.

GrablinkIEqSchTTL

Equivalent schematic in ITTL input mode

GrablinkIEqSch12V

Equivalent schematic in I12V input mode