CK Jumper Block
Domino boards have CK jumper blocks called CKX when associated to the Camera X connector and CKY when associated to the Camera Y connector.
The CK jumper blocks are used to configure the usage of the following camera connector pins.
Pin number |
Generic name |
Name on camera connector |
9 |
CK+ |
CK+ |
10 |
CK- |
CK- |
3 |
GND |
GND |
Non-inverted differential pixel clock (default setting)
This configuration is used with a non-inverted differential pixel clock signal. The pixel clock is applied to CK+ and CK-.
The MultiCam parameter JumperCK returns CKDPOS when a supported camera requires this configuration.
Inverted differential pixel clock
This configuration is used with an inverted differential pixel clock signal. The pixel clock is applied to CK+ and CK-.
The MultiCam parameter JumperCK returns CKDNEG when a supported camera requires this configuration.
Non-inverted single-ended pixel clock
This configuration is used with a non-inverted single-ended pixel clock signal. The pixel clock is applied to CK+ and GND.
The MultiCam parameter JumperCK returns CKSPOS when a supported camera requires this configuration.
Inverted single-ended pixel clock
This configuration is used with an inverted single-ended pixel clock signal. The pixel clock is applied to CK- and GND.
The MultiCam parameter JumperCK returns CKSNEG when a supported camera requires this configuration.
No pixel clock
If the camera does not use a pixel clock, the CK jumper block is empty with no jumper installed.
The MultiCam parameter JumperCK returns EMPTY when a supported camera requires this configuration.
